Search found 4 matches

by TooSlow2Care
Sat 18 Jun 18 2011 11:53 am
Forum: Support
Topic: DragonOSD+ - ArduIMU+ V2 firmware modification
Replies: 14
Views: 32188

Re: DragonOSD+ - ArduIMU+ V2 firmware modification

Ihave found some data regarding the Barometric sensor I am using, Here: http://hobbywireless.com/cart/index.php?main_page=product_info&products_id=633 they provide two fixes to what my problem might be, but i'm not sure if you have already written the code they refer to. "A warning to ArduIMU users ...
by TooSlow2Care
Fri 17 Jun 17 2011 11:05 pm
Forum: Support
Topic: DragonOSD+ - ArduIMU+ V2 firmware modification
Replies: 14
Views: 32188

Re: DragonOSD+ - ArduIMU+ V2 firmware modification

Daniel,
Can you show me the Pull-ups on the ARDUIMU? i see a direct trace from the Atmel chip to the SDA & SCL pins.
https://store.diydrones.com/PhotoDetail ... ARDUIMU-20

cheers,
Brian
by TooSlow2Care
Fri 17 Jun 17 2011 10:16 pm
Forum: Support
Topic: DragonOSD+ - ArduIMU+ V2 firmware modification
Replies: 14
Views: 32188

Re: DragonOSD+ - ArduIMU+ V2 firmware modification

I had no idea that i needed to remove any resistors or make any other harware changes to the ARDUIMU. Can you give me a link or a picture illustating what needs to be done? I am powering the ARDUIMU with a 2cell LiPo and the 3.3v pin is not connected to anything. thank you very much, Brian EDIT: aft...
by TooSlow2Care
Fri 17 Jun 17 2011 1:50 am
Forum: Support
Topic: DragonOSD+ - ArduIMU+ V2 firmware modification
Replies: 14
Views: 32188

Re: DragonOSD+ - ArduIMU+ V2 firmware modification

Daniel, I hate to bring this up because i know you are busy. I have updated my ARDUIMU V2 Flat with the Firmware (F) provided on this thread. Gone through the Calibration process illustrated by Kempo on Youtube. I Also have the Barometric Pressure Sensor from DIY Drones. the DOSD runs flawlessly as ...