Search found 4 matches
- Sat 18 Jun 18 2011 11:53 am
- Forum: Support
- Topic: DragonOSD+ - ArduIMU+ V2 firmware modification
- Replies: 14
- Views: 70474
Re: DragonOSD+ - ArduIMU+ V2 firmware modification
Ihave found some data regarding the Barometric sensor I am using, Here: http://hobbywireless.com/cart/index.php?main_page=product_info&products_id=633 they provide two fixes to what my problem might be, but i'm not sure if you have already written the code they refer to. "A warning to ArduI...
- Fri 17 Jun 17 2011 11:05 pm
- Forum: Support
- Topic: DragonOSD+ - ArduIMU+ V2 firmware modification
- Replies: 14
- Views: 70474
Re: DragonOSD+ - ArduIMU+ V2 firmware modification
Daniel,
Can you show me the Pull-ups on the ARDUIMU? i see a direct trace from the Atmel chip to the SDA & SCL pins.
https://store.diydrones.com/PhotoDetail ... ARDUIMU-20
cheers,
Brian
Can you show me the Pull-ups on the ARDUIMU? i see a direct trace from the Atmel chip to the SDA & SCL pins.
https://store.diydrones.com/PhotoDetail ... ARDUIMU-20
cheers,
Brian
- Fri 17 Jun 17 2011 10:16 pm
- Forum: Support
- Topic: DragonOSD+ - ArduIMU+ V2 firmware modification
- Replies: 14
- Views: 70474
Re: DragonOSD+ - ArduIMU+ V2 firmware modification
I had no idea that i needed to remove any resistors or make any other harware changes to the ARDUIMU. Can you give me a link or a picture illustating what needs to be done? I am powering the ARDUIMU with a 2cell LiPo and the 3.3v pin is not connected to anything. thank you very much, Brian EDIT: aft...
- Fri 17 Jun 17 2011 1:50 am
- Forum: Support
- Topic: DragonOSD+ - ArduIMU+ V2 firmware modification
- Replies: 14
- Views: 70474
Re: DragonOSD+ - ArduIMU+ V2 firmware modification
Daniel, I hate to bring this up because i know you are busy. I have updated my ARDUIMU V2 Flat with the Firmware (F) provided on this thread. Gone through the Calibration process illustrated by Kempo on Youtube. I Also have the Barometric Pressure Sensor from DIY Drones. the DOSD runs flawlessly as ...