IMU Support for DragonOSD+ v2
Posted: Thu 12 Jan 12 2012 2:15 pm
Supported IMU:
Razor 9DoF: http://www.sparkfun.com/products/10736
Mongoose 9DoF: http://store.ckdevices.com/products/Mon ... nsor-.html
(USE ONLY THE 16MHz CRYSTAL IMU ONLY)
These supported IMUs needs firmware to be loaded into them before they can work properly. Please download the IMU firmware below. Arduino software is needed to upload the IMU firmware to the IMU. Please see link: Arduino-0023 found here: http://arduino.cc/hu/Main/Software
A USB-TTL converter such as this (http://www.ebay.com/sch/i.html?_nkw=dra ... m270.l1313 ) is needed for Arduino to move the IMU files to the IMU. From the TTL you must connect TX to IMU TX, TTL RX to IMU RX, TTL (+) to IMU 3.3v (please see note below) and TTL GND to IMU GND
Note: TTL is 5v and IMU is 3.3v but this did not harm the Razor 9DoF IMU.
Razor 9DoF: http://www.sparkfun.com/products/10736
Mongoose 9DoF: http://store.ckdevices.com/products/Mon ... nsor-.html
(USE ONLY THE 16MHz CRYSTAL IMU ONLY)
These supported IMUs needs firmware to be loaded into them before they can work properly. Please download the IMU firmware below. Arduino software is needed to upload the IMU firmware to the IMU. Please see link: Arduino-0023 found here: http://arduino.cc/hu/Main/Software
A USB-TTL converter such as this (http://www.ebay.com/sch/i.html?_nkw=dra ... m270.l1313 ) is needed for Arduino to move the IMU files to the IMU. From the TTL you must connect TX to IMU TX, TTL RX to IMU RX, TTL (+) to IMU 3.3v (please see note below) and TTL GND to IMU GND
Note: TTL is 5v and IMU is 3.3v but this did not harm the Razor 9DoF IMU.