Tsebi Projects Forum

Here is a little video on how to solder Deans connectors then finishing off with the provided heat shrink tubing to cover everything up.

John

https://www.youtube.com/watch?v=AdmlB1e ... =autoshare

Version 17.8

Accepts new LS20031 GPS with MT3399 chipset

Version 17.3 (for V2 hardware)

1. SW assigned switch will now clear AHI (won't leave lines on screen)
2. minor optimizations (very insignificant)

Installing the supplied current sensor in the PWM pins may result in damaging the OSD PPM.

Connecting the supplied current sensor incorrectly may result in permanently damaging the MCU! DO NOT DO THIS! Make sure the black wire is facing the EDGE of the OSD!

Video of this in action:
http://vimeo.com/35678431

Now you are ready to fly!!

Once the firmware is loaded into your IMU and you did not receive an error message in Arduino, unplug the wires and connect the IMU to the Translator board and OSD. Power up the OSD, enter into menu mode and activate your artificial horizon by selecting values from 1 and up. Factory setting is (0) w...

If you receive a avrdude message in the black box of Arduino, this may mean you have connected the IMU incorrectly!

1) Press "upload"
2) When the message displays in the black box below, "Binary Sketch size..... ", quickly press the IMU "reset button."

Note: Razor IMU red and green LED will light up solid when the firmware has been loaded properly.

Double check your Board type and Serial Port under the "Tools" menu.