1. Install drivers for the CP2105 USB-serial chipset (can be obtained from the Yaesu page)
https://www.yaesu.com/downloadFile.cfm? ... compressed
2. In the radio, select FUNC->Radio Settings (bottom left)
- select MODE PSK/DATA
- leave Data Shift at 1500 (with DSP shift set to 0)
- DATA MOD SOURCE = REAR
- REAR SELECT = USB
- RPTT = DAKY (only use RTS if your PTT Method in JTDX is RTS)
- RPORT GAIN = 6 (or less - depends on the playback level)
- set low and high filter limits to OFF
3. In the radio, select FUNC->Operation Setting
- select GENERAL
- CAT RATE = 38400
- CAT RTS = ON
4. In JTDX, select Settings->Radio
- Rig = Yaesu FTDX101D
- select the appropriate COM port (from Device Manager->COM ports)
- Baud Rate = 38400 (should be set in the radio as well)
- Data Bits = Eight
- Stop Bits = One
- Handshake = None
- DTR = High
- RTS = High
- PTT Method = CAT (RTS works but will TX during reboot)
- Mode = Data/Pkt
- Split Operation = Fake It
5. In JTDX, Select Settings->Audio
Input = USB AUDIO CODEC (FT-DX10 from radio)
Output = USB AUDIO CODEC (FT-DX10 to radio)
6. In the radio - make sure mode is DATA-U or DATA-L as appropriate
- from screen, set RF Filter width to 3kHz
- from the right side knob, set SDR filter width to 3kHz
7. AGC = FAST
It seems to take quite a while before all these changes register in JTDX so just give it a long while. Maybe reboot the PC and power down the radio and turn it on again.
Setting up FT-DX10 with JTDX
-
- Site Admin
- Posts: 2449
- Joined: Wed 25 Feb 25 2009 8:00 pm